Birkenstocks are cork-bottomed shoes that accept a rubber sole on the bottom for grip and comfort. The prophylactic sole volition vesture out over fourth dimension, necessitating the replacement and repair of the sole or the replacement of the unabridged shoe. Since it is easier (and less expensive) to repair the sole, many people cull that option. Repairing the rubber part of a Birkenstock is a quick, elementary process, and the shoes will be ready to wear over again the next day.

  • Birkenstocks are cork-bottomed shoes that have a rubber sole on the bottom for grip and comfort.
  • The condom sole volition habiliment out over time, necessitating the replacement and repair of the sole or the replacement of the entire shoe.

Inspect the lesser of the Birkenstock for signs of vesture. Audit the width of the remaining rubber sole. If less than 1/four inch of the sole remains on whatsoever part of the sole, so the rubber should be replaced. If merely the heel and toe rubbers are worn, and then you tin supplant them with safe toe taps.

Wash the prophylactic sole with balmy soap and a soft bristle brush. Remove all dirt, oil and other gunk from the lesser of the shoe. Dry the sole with an erstwhile towel.

Apply a line of glue between cracks in the rubber sole that is thick enough to remain on the shoe. Employ gum to any loose rubber that does not need removal as well. Press the two pieces together for virtually one minute to let the glue time to gear up.

  • Wash the prophylactic sole with mild lather and a soft bristle brush.
  • Apply a line of glue between cracks in the rubber sole that is thick enough to remain on the shoe.

Cut the areas of the safety that you are removing very carefully with a utility knife. Make cuts as clean as possible. Gently pull the prophylactic sole abroad from the cork lesser of the shoe.

Sand the cork area of the shoe gently with sandpaper to remove any remaining adhesive and to roughen and even the surface of the cork for better adhesion. Dust any sandpaper abroad with a clammy rag.

Place the heel and toe taps or the entire new shoe sole over the bottom of the shoe. Don't worry if the rubber is too large for the shoe at this point. Yous will remove backlog safety once the glue dries.

Utilize a bead of silicone gum all around the area of the shoe where you volition attach the new rubber piece. Spread the glue with a paint scraper. Press the rubber piece in identify. Permit the glue to dry for nearly two hours.

  • Sand the cork surface area of the shoe gently with sandpaper to remove any remaining adhesive and to roughen and even the surface of the cork for better adhesion.
  • Apply a bead of silicone gum all around the area of the shoe where you will adhere the new safe piece.

Sand the edge of the prophylactic where it lines upwardly with the original safety piece to create an fifty-fifty surface. Cut any prophylactic that sticks out from the shoe with a utility pocketknife.